Iron Patch Instructions

What You’ll Need:

• Clean garment or fabric (cotton or denim works best)
  
• Iron (no steam)
  
• Thin cloth or parchment paper
  
• Flat, heat-safe surface (like an ironing board)
  

Steps:

1. Prep the Fabric
   Wash and dry the garment first to remove finishes or shrinkage.
   Lay it flat on the ironing board with the area you’ll apply the patch smoothed out.
   
   
2. Place the Patch
   Position the patch where you’d like it.
   Make sure it’s straight and centered before heating.
   
   
3. Cover & Protect
   Place a thin cloth (like a pillowcase) or parchment paper over the patch.
   This protects the embroidery threads from direct heat.
   
   
4. Iron the Patch
   Heat the iron to medium-high (about 350°F / 175°C).
   Press the iron down firmly on top of the covered patch for 15–20 seconds.
   
   Don’t move the iron around—hold it in place with steady pressure.
   
   
5. Flip & Seal
   Turn the garment inside out.
   Iron the back of the patch area for another 15–20 seconds to fully melt the adhesive.
   
   
6. Let It Cool
   Allow the patch to cool completely (about 5 minutes).
   Check the edges; if any lift, repeat the process.
   
   

For Best Results:

• Reinforce with stitching (especially on high-wear areas like jackets, backpacks, or hats).
  
• Avoid delicate fabrics (silk, nylon, leather) as the heat may damage them.
  
• Wash inside out with cold water to extend patch life.
  

⚠️ Important: If your patch is on a stretchy or slick material (polyester, nylon, leather), sewing it on is recommended instead of ironing.